Installation Guide

FV563 Rev. F 5/9/2016
Page 3
Overview:
Zurn° Aqua-FIT° Series Sensor™ Faucets features multiple spout designs in a standard polished chrome finish with one
piece heavy duty cast brass spouts and advanced electronic components and feature sets. Sophisticated automatic user
detection and self-calibration ensures the user does not need to touch the faucet and helps deliver optimum water
savings.
NOTE: The information in this manual is subject to change at any time without notice. Installations may be performed
at different times of construction by different individuals. For this reason, these instructions should be left on-site
with the facility or maintenance manager.
Specifications:
Voltage: 6 VDC Series [4 “AA” (Alkaline or Lithium) and/or external power option]
Sensor Range: Self-calibrated, dependent upon sink depth and finish.
Operating Water Pressure: 10-125 psi
Operational Water Temperature: 33°F to 140°F (1°C to 60°C)
Aerator: 1.5 GPM Vandal-Resistant (Standard)
Important Safety Information:
• Installer is responsible for ensuring the product is installed and conforms to all plumbing codes and ordinances.
• Do not convert or modify this Zurn product yourself. All warranties will be voided.
• Water supply lines must be sized according to building designer in order to provide adequate water supply for each fixture.
• Flush all water lines prior to making connections.
Prior to Installation:
Before installing your Zurn
®
Aqua-FIT
®
Faucet: the items listed below should already be installed on site.
• Lavatory/sink
• Drain Line
• Hot and cold water supply line or pre-tempered water supply line.
• Installer/Servicer should not use pipe dope or teflon/thread sealant anywhere on this product, most notably threads and
connection points.
• Care shall be taken when installing this product to prevent marring of any exposed or decorative surfaces.
Be sure the sink/lavatory/basin is clear from any objects upon making the sensor to electronics connection initiating the self-
calibration feature. The sink must be clear of any and all objects in order to calibrate appropriately (calibration time approx
30-60sec).