Installation Sheet

Zurn Industries, LLC
5900 Elwin Buchanan Drive, Sanford, NC U.S.A. 27330 · Ph. 1-800-997-3876, Fax [phone]
In Canada
| Zurn Industries Limited
7900 Goreway Drive Unit 10, Brampton, Ontario L6T5W6 · Ph. 905-405-8272, Fax [phone]
www.zurn.com
Rev. B
Date: 10/29/2018
C.N. No. SAN008373
Prod. | Dwg. No. IS7080
 Installation  Maintenance Instructions
Z7000-HS
Hand Shower
Wall Mount/Swivel Mount Installation
Position wall mount where desired (shower head will be
approximately 4" above mount). Mark hole locations on wall
surface. Be sure mount is straight. Remove mount. Slightly
nick center of holes with center punch. Drill holes. Insert plastic
anchors into holes. Place mount in position insert screws.
Tighten.
Shower arm diverter used in the “-HS” assembly should be
installed between the shower arm & shower head.
Shower Arm Diverter Installation
Thread swivel connection on to your present shower arm. Be
sure all gaskets are in place. Attach shower head onto end of
diverter in-line with shower arm. Attach hose to fi tting 90° from
center-line of shower head. Tighten all fi ttings and your shower
is ready to use.
-VB Option: If your hand shower assembly has been equipped with
an in-line (-VB) vacuum breaker, be sure hose end with vacuum
breaker is connected at water supply end (NOT TO HANDSET).
Diverter Valve Installation
Wall Bar Installation
TEMP-GARD
WARNING: Cancer and Reproduc ve Harm - www.P65Warnings.ca.gov
ADVERTENCIA: Cáncer y daño reproduc vo - www.P65Warnings.ca.gov
AVERTISSEMENT: Cancer et eff ets néfastes sur la reproduc on - www.P65Warnings.ca.gov