Installation Sheet



 Installation


 Maintenance Instructions
Z7000-HS
Hand Shower
Form # IS7080 Date: 12/15/11 Product No.: IS7080
C.N. No. 128416 Rev. A Sheet 1 of 1
Wall Mount/Swivel Mount Installation
Position wall mount where desired (shower head will be
approximately 4" above mount). Mark hole locations on wall
surface. Be sure mount is straight. Remove mount. Slightly
nick center of holes with center punch. Drill holes. Insert
plastic anchors into holes. Place mount in position insert
screws. Tighten.
Shower arm diverter used in the “-HS” assembly should be
installed between the shower arm & shower head.
Shower Arm Diverter Installation
Thread swivel connection on to your present shower arm. Be
sure all gaskets are in place. Attach shower head onto end of
diverter in-line with shower arm. Attach hose to fitting 90°
from center-line of shower head. Tighten all fittings and your
shower is ready to use.
-VB Option: If your hand shower assembly has been
equipped with an in-line (-VB) vacuum breaker, be sure hose
end with vacuum breaker is connected at water supply end
(NOT TO HANDSET).
Diverter Valve Installation
Wall Bar Installation
AquaSpec
®
is a registered trademark of Zurn Industries,LLC
©2010 Zurn Industries, LLC
TEMP-GARD
ZURN INDUSTRIES, LLC.
♦♦
♦♦
♦ COMMERCIAL BRASS OPERATION
♦♦
♦♦
♦ 5900 ELWIN BUCHANAN DRIVE
♦♦
♦♦
♦ SANFORD NC 27330
Phone: [phone]
♦♦
♦♦
♦ Fax: [phone]
♦♦
♦♦
♦ World Wide Web: www.zurn.com
In Canada: ZURN INDUSTRIES LIMITED
♦♦
♦♦
♦ 3544 Nashua Drive
♦♦
♦♦
♦ Mississauga, Ontario L4V1L2
♦♦
♦♦
♦ Phone: [phone] Fax: [phone]