Specification Sheet

Rev. D Date: 8/30/11 C.N. No.128086
Dwg. No. 92155 Product No. Z7300-SS-MT-HW6
AquaSpec
®
is a registered trademark of Zurn Industries, LLC
©2008 Zurn Industries, LLC
____________________________
TEMP-GARD III SHOWER UNIT
Z7300-SS-MT-HW6
TAG _______
ZURN INDUSTRIES, LLC
♦♦
♦♦
♦ COMMERCIAL BRASS OPERATION
♦♦
♦♦
♦ 2640 SOUTH WORK STREET
♦♦
♦♦
♦ FALCONER NY 14733
Phone: [phone]
♦♦
♦♦
♦ Fax: [phone]
♦♦
♦♦
♦ www.zurn.com
In Canada: ZURN INDUSTRIES LIMITED
♦♦
♦♦
♦ 3544 Nashua Drive
♦♦
♦♦
♦ Mississauga, Ontario L4V1L2
♦♦
♦♦
♦ Phone: [phone] Fax: [phone]
ENGINEERING SPECIFICATIONS: ZURN Z7300-SS-MT-HW6
Single handle pressure balancing mixing tub and shower unit, ceramic control cartridge
with stainless steel balancing piston, built in reverse connection capability (To reverse the
hot and cold inlets simply remove cartridge and turn 180
o
), two service stops / check stops,
and adjustable limit stop. When valve is turned on it must rotate from cold through to the
hot position. All exposed trim and handle are metal with polished nickel chrome plated
surface. Valve supplied with standard 2.5 GPM hand/wall shower head, hand/wall unit,
60"[1524mm] flexible metal hose, 24"[610mm] mounting bar, vacuum breaker, supply elbow
and flange. The valve inlets, shower and tub outlet are all standard with 1/2" NPT female
thread connections. The 1/2" copper sweat options must be specified as shown below.
OPTIONS (Check/specify appropriate options)Use with Z7300 prefix
Suffix Description
___ -EXT Extension Kit, Extends Valve Out by 1".
___ -SSC 1/2" Female Copper Sweat Connections w/ Service Stops
___ -ST Sierra Series Decorative Metal Trim
___ -WF Wall Mounting Flange For Fiberglass or Panel Wall Installation
___ - Handwall Options (see Z7000-HW)
Note: All dimensions are for reference only. Do not use for pre-plumbing.
Parts shown as hidden lines are supplied by others.
Additional Options
___ Z7000-SC Pair of Dual Spring Check Valves
STANDARDS
Tested to meet the following standards for
valves and plumbing fittings:
ASSE Standard No. 1016
ASME A112.18.1 / CSA B125.1
IAPMO
®
Listed
Meets or Exceeds ANSI A117.1M standard
for physically handicapped
®®
®®
®