Installation Guide

ManualsBrandsZurn ManualsOtherAqua Sense ZER-TM Series EZ Gear-Driven 1.1 GPF Exposed Sensor Diaphragm Water Closet Flush Valve

FV669 Rev. B 10/14/2019

Page 3

Sweat Solder Adapter Installation Instructions - STEP 1

STEP 1.1

Measure distance from nished wall to the center line of the xture

spud. If necessary, cut water supply pipe 1-1/4” shorter than this

measurement. Deburr by chamfering O.D. and I.D of end of water

supply pipe.

STEP 1.3

Measure distance from nished wall to rst thread of sweat solder

adapter. If necessary, cut chrome cover tube this length.

STEP 1.4

Slide wall escutcheon over chrome cover tube and slide both

items over water supply pipe. Press wall escutcheon ush against

nished wall and tighten set screw with hex wrench (supplied) to

secure it in place.

STEP 1.2

Slide threaded sweat solder adapter onto water supply pipe until

shoulder stops on end of pipe. Then sweat-solder the adapter to

water supply pipe.

STEP 2.1

Install control stop assembly by threading it onto water supply pipe

and tightening with a smooth jawed wrench. Apply thread seal-

ing compound or pipe tape to male NPT thread on sweat solder

adapter only.

Prior to turning on main water supply line ensure all stop valves

are closed o󰀨 tight by using a athead screwdriver and turning

the stop valve adjustment screw clockwise.

Apply sealing

compound here

Control Stop Installation Instructions - STEP 2

Using a athead screwdriver, turning

counterclockwise, ush supply line

by opening the control stop. Turning

clockwise will close control stop.

STEP 2.2

When all stop valves are properly connected to the water supply

line and water pressure is available open the control stop using a

athead screwdriver and turning the stop valve adjustment screw

counterclockwise.

Allow the water supply line to ush any debris or sediment that may

be present in the line.

Close the control stop once the lines are completely ushed.

Figure 1 Figure 2

Figure 3 Figure 4

Figure 5 Figure 6

NOTE: Before installation, turn o󰀨 water supplies to existing xture and remove ushometer if replacing an existing device.

Sweat Solder Adapter

Set Screw

Chrome Cover Tube

Wall Escutcheon

Finished Wall

Water Supply Pipe

C of Fixture Spud

'X'