User manual

Camera Installation
!
!
6. If you need to adjust the
viewing angle, l o osen the
6
screws on the sides of the
ball camera and adjust the
ball camera. Do not remove
the screws holding the ball
camera. Tighten the scr ews
when finished.
!
NOTE: Ensure the ball
c a mer a is point ed in the same
direction as the IR LED t o
ensure a good nighttime
image.
!
!
!
!
Loosen screws to adjust the
angle of the ball camera
!
!
!
!
IR LED
Do not remove the screws
holding the ball camera.
!
7. Ensure the rubber gask et
inside the camera is
7
properly in place, then
replace the camera c o v e r
and the camera cove r
screws (2x).