User Manual

6 Quick Setup Guide
Volume
These appropriately named buttons
control the volume.
Power
The POWER button switches the ZVOX
speaker between Standby and On.
Note: The ZVOX AV157 will also enter
Standby if it receives no audio signal for
approximately 30 minutes. A command
from a remote control or a restored audio
signal will turn it back on.
Input Selection
Press the INPUT button on the ZVOX
remote to select between the speaker’s
two inputs.
The choices are:
Optical digital — IN1d
Analog minjack — In2A
Both inputs at the same
time – both
Mute
Press this button to mute the ZVOX speaker.
When MUTE function is active, the display
blinks “-00-”. The AV157 will enter Standby
if it is left in MUTE for longer than ve
minutes.
Button Functions on the
ZVOX Remote Control
Remote Control Button Layout.
INPUT
SURROUND
POWER
MUTE
ACCUVOICE
VOLUME
SuperVoice Setting For Extreme Voice Clarity
People with hearing loss will appreciate the extra boost provided by the new
SuperVoice
TM
feature. SuperVoice uses advanced compression algorithms to
lift voices out of the other sounds in a TV show, sporting event or movie.
To activate SuperVoice mode press and hold the AccuVoice button on the
remote control for about four seconds. The display on the AV157 will the
change for “AC 1” to “SUP1” – indicating the speaker is in “SuperVoice
1” mode. Continue with quick presses to the AccuVoice button to select
increasing levels of voice enhancement. There are six levels of SuperVoice
enhancement, starting with SUP1 going up to SUP6. The setting you select
remains the default AccuVoice setting until you decide to change it.
To revert from SuperVoice mode back to AccuVoice mode, press and hold
the AccuVoice button on the remote control for about four seconds.
Surround Settings
There are three SURROUND levels:
• Surround One (“Sd 1”) has low virtual surround
effect and strong vocals. Use this setting if vocal
clarity is important to you.
• Surround Two (“Sd 2”) has moderate virtual
surround effect and moderate vocals. This is the
recommended setting for general TV programs.
• Surround Three (“Sd 3”) has strong virtual
surround effect and moderate vocals. Many
people prefer this setting when watching movies.
AccuVoice
Press the AccuVoice button to select the AccuVoice function. Additional
presses of the AccuVoice button allow you to select increasing levels of voice
enhancement. There are six levels of AccuVoice enhancement, starting with
AC 1 going up to AC 6. The setting you select remains the default AccuVoice
setting until you decide to change it.
UP TO
“Alexa
®
Ready” Feature
It’s simple to integrate an Amazon® Echo®, Echo Dot or Echo Input to the
AV157. Connect your TV to Input 1. Connect the Echo device (via 3.5mm cord)
to Input 2. Then set input selection to “both,” by pressing and holding the INPUT
button for ve seconds. If you are watching a TV program and ask “Alexa” a
question, the AV157 will turn down the TV sound while Alexa answers your
question. When Alexa stops speaking, the AV157 turns up the TV sound. To
switch back to Input 1 or 2, press and hold the INPUT button for ve seconds.
UP TO