User Manual
ZyLink Wireless Control
The F8-200 has built-in wireless control for adjustment up to 50’ (15m) away
using the Zylight Remote or other Zylight instrument (available separately).
ZyLink Operation: To enable ZyLink control, push & quickly release the
MODE knob, then turn the knob to select the desired wireless channel (1-10).
A wireless symbol will appear in the display when ZyLink is enabled. To
disable ZyLink turn the knob until the display shows OFF.
NOTE: DMX control and ZyLink cannot be enabled at the same time.
About DMX
DMX is a language allowing all makes and models of different manufactures
xtures to be linked together and operate from a single controller, as long as
all xtures and the controller are DMX compliant. A DMX controller sends DMX
data instructions from the controller to the instrument. DMX is the control data
from the DMX controller sent via 5 pin DMX cable to a single xture, multiple
lighting xtures or instruments utilizing the DMX Data IN and DMX Data OUT
jacks located on all DMX enabled instruments.
To ensure proper DMX data transmission, when using several DMX xtures, try
to use the shortest cable path possible. The order in which xtures are
connected in a DMX line does not inuence the DMX channel addressing. For
example; a xture assigned to a DMX address of 1 may be placed anywhere
in a DMX line, at the beginning, at the end, or anywhere in the middle. When a
xture is assigned a DMX address of 1, it will “listen” for any DATA command
sent by the DMX controller to channel 1 and respond accordingly no matter
where it is located in the DMX chain.
Page 11
Pack
Flood
Spot