User Manual

fig 3
Page 7
Fig 1 – open Fig 2 – locked
Fig 4Fig 3
Barn Door Installation
The F8 includes a set of compact 4-way barn doors as part of the kit. The barn
doors are installed by way of 4 barn door ears. There are two positions for the
barn door ears – open (the packed position) and locked (or the forward
position). Please refer to gures 1 and 2 to understand the different positions
of the barn door ears.
To lock the barn doors ears in place to securely hold the barn doors or any
scrims or gels, push the barn door ears forward (towards the front of the light).
Each barn door ear will ‘click’ into a locked position (Fig 3). To release each
barn door ear, push center tab of the barn door ear towards the back of the
xture and the barn door ear will release (Fig 4). Make sure that each barn door
ear is securely locked into position before proceeding to the next one.
To properly install the barn doors, clip and lock the two lower barn door ears
(the two closest to the ground). Clip and lock the top barn door ear that is
furthest from your reach. This will leave one barn door ear still in its ipped
back (packed) position (Fig 5). Loop and attach a safety cable to a high secure
point within your xture, grid, or stand (Fig 6). Attach the other end to one of
the top holes found on the four corners of the face of the center portion of the
barn door (Fig 7). This tethers the barn door so in case of an accidental
release, the barn doors will hang next to the xture and not fall away from the
xture. Failure to properly tether the barn doors can create a dangerous
circumstance for anyone positioned below the xture.