User's Manual

ENG - 17
AV Delay
Function LED Behavior Description
Program Remote
Learn
Waiting to learn:
Flash from bottom
to top and back
continuously.
SETUP > PrgRemote > Use the Next/Previous buttons and OK button to toggle and
select and program your TV remote to control the Volume Down, Volume Up, and Mute
functions on your sound bar. See the
Programing the Sound Bar on page 20 section for
more information.
Power LED
Power LED On
SETUP > PwrLED > Use the Next/Previous buttons and OK button to enable/disable the
Power LED.
Note: Turning the Power LED o also mutes most voice announcements.
Power LED O
AV Delay
LED at the bottom
indicates no delay.
SETUP > AV Delay > Use the Next/Previous buttons to increase/decrease the amount of
audio delay. The LED indicators will move to the top with increasing audio delay level.
Reset Audio or
Reset All
All LEDs will ash
3 times when
settings are reset.
SETUP > Reset Audio or Reset All > Use the Next/Previous buttons to reset either Audio
or All settings. Press the OK button to select.
Audio - Only audio settings, such as bass and treble levels, will be reset.
All - All paired Bluetooth devices will be unpaired and all settings will be lost. All
programmed IR remotes will also be removed. See the
Factory Reset on page 19 for
more information.
Speaker Test
—
SETUP > Spkr Test > OK to activate the speaker test function. A voice will begin calling
out each speaker beginning with
left front (Left Front, Right Front, Right Rear, Left Rear,
and Subwoofer-white noise). If any of these are missing, check the connection and run the
speaker test function again.
VIZIO Remote
Remote On
SETUP > VZtvRmt > Use the Next/Previous buttons to enable/disable VIZIO TV
Remotes. When enabled (On), you can use a VIZIO TV remote control to turn on the sound
bar (using the TV Volume Up button) and control volume.
Remote O
PwrLED
Reset All
Prg Remote
Spkr Test
VZtvRmt
Mode & Level Settings