Internet Security Appliance User's Guide

Chapter 36 WAN and Dial Backup Setup
ZyWALL 5/35/70 Series User’s Guide
631
Retype to
Confirm
Enter your password again to make sure that you have entered is correctly.
Authen This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP - Your ZyWALL will accept either CHAP or PAP when requested by this
remote node.
CHAP - accept CHAP only.
PAP - accept PAP only.
Pri Phone # Enter the phone number (dial string) used to dial up a connection to your service
provider’s base station. Your ISP should provide the phone number.
For example, *99# is the dial string to establish a GPRS or 3G connection in Taiwan.
Edit IP This field leads to a “hidden” menu. Press [SPACE BAR] to select Yes and press
[ENTER] to go to Menu 11.3.2 - Remote Node Network Layer Options. See
Section 36.3.4 on page 625 for more information.
Edit Script
Options
Press [SPACE BAR] to select Yes and press [ENTER] to edit the AT script for the
dial backup remote node (Menu 11.3.3 - Remote Node Script). See Section 36.3.5
on page 626 for more information.
Always On Press [SPACE BAR] to select Yes to set this connection to be on all the time,
regardless of whether or not there is any traffic. Select No to have this connection act
as a dial-up connection.
Session
Options
Edit Filter sets This field leads to another “hidden” menu. Use [SPACE BAR] to select Yes and press
[ENTER] to open menu 11.3.4 to edit the filter sets. See Section 36.3.6 on page 628
for more details.
Idle Timeout Enter the number of seconds of idle time (when there is no traffic from the ZyWALL to
the remote node) that can elapse before the ZyWALL automatically disconnects the
3G connection.
Once you have configured this menu, press [ENTER] at the message “Press ENTER to Confirm...” to
save your configuration, or press [ESC] at any time to cancel.
Table 223 Menu 11.2: Remote Node Profile (3G WAN) (continued)
FIELD DESCRIPTION