Network Device User's Guide Omni 56K Plus Series

Omni 56K Plus Series User’s Guide
4-6 Command Sets
Table 4-3 Extended AT& Command Sets
COMMAND OPTIONS FUNCTION & DESCRIPTION REF.
&R0 CTS tracks RTS, response delay is set in S26.
&R1 * Ignore RTS, assumes RTS always ON.
&Sn Data Set Ready (DSR) function selection. S21.3
&S0 * DSR overridden, DSR always ON.
&S1 DSR according to CCITT (ITU-TSS). (See also S41.5, S44.4)
&Tn Modem testing. S16
&T0 Terminate test in progress.
&T1 Initiate Analog Loop-back (ALB) test.
&T3 Initiate Local Digital Loop-back (LDL) test.
&T4 Grant Remote Digital Loop-back request from remote modem. S14.1
&T5 Deny Remote Digital Loop-back request from remote modem. S14.1
&T6 Initiate Remote Digital Loop-back (RDL) test.
&T7 Initiate Remote Digital Loop-back with self test. (RDL+ST)
&T8 Initiate Analog Loop-back with self test. (ALB+ST)
&Vn View profile settings.
&V0 View current active settings.
&Vn View the (n-1) user profile settings (n=1-2)
&V3 View factory default settings.
&Wn n=0-1 Save current settings to user profile n in non-volatile RAM. (See
also S35.6)
&Yn Break handling. Destructive Break clears the buffer. Expedited
Break is sent immediately to the remote system.
S28.2-3
&Y0 Destructive, expedited.
&Y1 * Nondestructive, expedited.
&Y2 Nondestructive, unexpedited.
&Z? Display all the phone numbers stored in non-volatile RAM.
&Zn=s n=0-3 Store phone number/s to NVRAM at location n (n=0-3) use
AT*Dn or ATS29=n to set the default dial pointer.
4.1.3 Extended AT* Command Sets
Table 4-4 Extended AT* Command Sets
COMMAND OPTIONS FUNCTION & DESCRIPTION REF.
*Cn Character length, including start, stop and parity bit. S15.3-4
*C0 * 10-bit character length
*C1 11-bit character length
*C2 9-bit character length