Network Device User's Guide Omni 56K Plus Series

Omni 56K Plus Series User’s Guide
Command Sets 4-11
Table 4-9 Supported Commands (per TIA PN2388 8/20/90)
COMMAND DESCRIPTION VALUE
+FDR Receive phase C data command; initiates document reception.
+FDT=df,vr,wd, ln Transmit phase C data command: release the DCE to proceed with
negotiation.
+FET=n End of page or document command:
More pages; same document. n=0
End of document; another document follows. n=1
No more pages or documents. n=2
Procedure interrupt; another page follows. n=4
Procedure interrupt; end of document, another document follows. n=5
Procedure interrupt; end of document. n=6
+FK Regular fax abort command.
+FLID="string" Local ID string parameter.
+FLO=n Flow control options:
No flow control. n=0
Set XON/XOFF software flow control. n=1
Set CTS/RTS hardware flow control. n=2
+FLPL=n Document for polling command:
The DTE has no document available for polling. n=0
Indicate a document available for polling. n=1
+FMDL? Request DCE model.
+FMFR? Request DCE manufacturer.
+FMINSP=n Minimum phase C speed parameter:
2400 bps. n=0
4800 bps. n=1
7200 bps. n=2
9600 bps. n=3
12000 bps. n=4
14400 bps. n=5
+FPHCTO=
<value>
DTE Phase C response time-out:
Determine how long the DCE will wait for a command after reaching
the end of data when transmitting in Phase C.
<value>=0 to 255; 100 ms units.
0-255
+FPTS=n Page transfer status
Received page good. n=1
Page bad; retrain requested. n=2
Page good; retrain requested. n=3