Network Device User's Guide Omni 56K Plus Series

Omni 56K Plus Series User’s Guide
4-12 Command Sets
Table 4-9 Supported Commands (per TIA PN2388 8/20/90)
COMMAND DESCRIPTION VALUE
Page bad; procedure interrupt requested. n=4
Page good; procedure interrupt requested. n=5
+FREL=n Phase C received EOL alignment:
The EOL patterns are bit aligned as received. n=0
The last received bits of EOL patterns are byte aligned by the DCE,
with necessary zero fill bits inserted. Refer to TIA PN-2388 for details.
n=1
+FREV? Request the DCE revision identification.
+FSPL=n "Enable polling" command:
Disable polling. n=0
Enable polling. n=1
All other +F commands are not supported, but the modem will respond OK. In many cases this means
"don't care".
Table 4-10 Class 2 Command Responses
RESPONSE VALUE FUNCTION AND DESCRIPTION
+FCFR Confirmation .
+FCIG:"string" Report remote ID response CIG.
+FCON Facsimile connection response.
+FCSI:"string" Report remote ID response CSI.
+FDCS:vr,br,wd,ln,df,ec,bf,st Report session parameters response; refer to +FDCC=....
command.
+FDIS:vr,br,wd,ln,df,ec,bf,st Report session negotiation parameters response; refer to
+FDCC=.... command.
+FDTC:vr,br,wd,ln,df,ec,bf,st Report remote capabilities response; refer to +FDCC=....
command.
+FET:n Post page message response; refer to the +FET=n command.
Call termination status response.
n=00 Normal and proper end of connection.
n=10 Transmit error on phase A hang up code.
n=20 Transmit error on phase B hang up code.
n=40 Transmit error on phase C hang up code.
n=50 Transmit error on phase D hang up code.
n=70 Receive error on phase B hang up code.
n=90 Receive error on phase C hang up code.
+FHNG:n
n=100 Receive error on phase D hang up code.
+FNSC:"HEX string" Report the non-standard facilities command frame.
+FNSF:"HEX string" Report the non-standard facilities frame response.
+FNSS:"HEX string" Report the non-standard setup frame response.