User's Manual

Chapter 15 RIP
CellPipe 7130 RG User’s Guide
218
The following table describes the labels in this screen.
Table 67 Advanced > RIP
LABEL DESCRIPTION
Interface This is the name of the interface in which the RIP setting is used.
Version The RIP version controls the format and the broadcasting method of the
RIP packets that the CellPipe 7130 RG sends (it recognizes both formats
when receiving). RIP version 1 is universally supported but RIP version 2
carries more information. RIP version 1 is probably adequate for most
networks, unless you have an unusual network topology.
Operation Select Passive to have the CellPipe 7130 RG update the routing table
based on the RIP packets received from neighbors but not advertise its
route information to other routers in this interface.
Select Active to have the CellPipe 7130 RG advertise its route
information and also listen for routing updates from neighboring routers.
Enabled Select the check box to activate the settings.
Apply/Save Click Apply/Save to save your changes back to the CellPipe 7130 RG.