User`s guide

A-6000 High Speed, Long Range Ethernet Wireless Bridge
CLI commands 4-4
(16) To display/modify data rate
Use the get/set rate command to display or modify the data rate. Select one of the following data rates: 6, 9,
12, 18, 24, 36, 48, 54, and best, respectively. The first 8 data rates are fixed rates and the last one is a variable
rate. When choosing the best rate, the BU attempts to deliver unicast data packets at the highest possible
optimum data rate. If there are obstacles or interference, the BU automatically steps down to an optimum data
rate that allows for reliable data transmission. In addition, the optimum data rate is adjusted periodically by the
BU, based on past performance of the data transmissions at different neighboring data rates.
-> get rate
Data Rate: best
-> set rate 36
Data Rate: 36
(17) To display/modify SNTP Server
Use the get sntpserver command to display or modify the SNTP/NTP server IP address.
-> get sntpserver
SNTP/NTP Server IP address:
-> set sntpserver 192.168.1.20
SNTP/NTP Server IP address: 192.168.1.20
(18) To display station status
Use the get station command to display station information and status.
-> get station
MacAddr: 00:03:7f:00:00:01, State: associated, AID: 1
Authentication Type: Open System
Encryption: ON, slot 4 shared[1] 40b key: aabbccddee
Power Save Mode: OFF
Rx Data Rate: 36, RxSignalStrength: 46, AckSignalStrength: 45
MSDU Data Mcast Mgmt Ctrl Errors
Rx 70 68 68 2 0 0
Tx 227 225 0 2 0 0
(19) To display/modify SSID
Use the get/set ssid command to display or modify the SSID. The SSID is a text string of up to 32 characters
in length. Control characters are not allowed.
-> get ssid
SSID: ZyXEL 802.11a Wireless Network
-> set ssid Internet Cafe Access Point
SSID: Internet Cafe Access Point
(20) To display/modify SSID Suppress
Use the get/set ssidsuppress command to display or modify the SSID suppress mode. When enable, the
SSID in beacons are not transmitted and only STAs with knowledge of an BU’s SSID are able to associate with
the BU.
-> get ssidsuppress
SSID Suppress Mode: Disabled
-> set ssidsuppress enable
SSID Suppress Mode: Enabled
-> set ssidsuppress disable
SSID Suppress Mode: Disabled
(21) To display/modify System Name
Use the get/set systemname command to display or modify the basestation unit system name. The system
name is the name of the basestation unit, and is a text string of up to 32 characters in length. Control
characters are not allowed.
-> get systemname
System Name:
-> set systemname My BU
System Name: My BU
My BU ->