User's Manual
Table Of Contents
- User’s Guide
- Copyright
- Certifications
- ZyXEL Limited Warranty
- Safety Warnings
- Customer Support
- Table of Contents
- List of Figures
- List of Tables
- Preface
- Getting Started
- Tutorial
- Wireless LAN Network
- ZyXEL Utility Configuration
- Maintenance
- Troubleshooting
- Product Specifications
- Management with Wireless Zero Configuration
- Wireless Security
- Types of EAP Authentication
- EAP-MD5 (Message-Digest Algorithm 5)
- EAP-TLS (Transport Layer Security)
- EAP-TTLS (Tunneled Transport Layer Service)
- PEAP (Protected EAP)
- LEAP
- Dynamic WEP Key Exchange
- WPA and WPA2
- Encryption
- User Authentication
- WPA(2)-PSK Application Example
- WPA(2) with RADIUS Application Example
- Security Parameters Summary
- Setting up Your Computer’s IP Address
- Index
ZyXEL AG-120 User’s Guide
Chapter 3 Wireless LAN Network 37
have the wireless client search for an OTIST-enabled AP, there is no timeout; click
Cancel in the OTIST progress screen to stop the search.)
3 When the wireless client finds an OTIST-enabled AP, you must still click Start in the AP
OTIST web configurator screen or hold in the Reset button (for one or two seconds) for
the AP to transfer settings.
4 If you change the SSID or the keys on the AP after using OTIST, you need to run OTIST
again or enter them manually in the wireless client(s).
5 If you configure OTIST to generate a WPA-PSK key, this key changes each time you run
OTIST. Therefore, if a new wireless client joins your wireless network, you need to run
OTIST on the AP and ALL the wireless clients again.