User's Manual
Table Of Contents
- User’s Guide
- Copyright
- Certifications
- ZyXEL Limited Warranty
- Safety Warnings
- Customer Support
- Table of Contents
- List of Figures
- List of Tables
- Preface
- Getting Started
- Tutorial
- Wireless LAN Network
- ZyXEL Utility Configuration
- Maintenance
- Troubleshooting
- Product Specifications
- Management with Wireless Zero Configuration
- Wireless Security
- Types of EAP Authentication
- EAP-MD5 (Message-Digest Algorithm 5)
- EAP-TLS (Transport Layer Security)
- EAP-TTLS (Tunneled Transport Layer Service)
- PEAP (Protected EAP)
- LEAP
- Dynamic WEP Key Exchange
- WPA and WPA2
- Encryption
- User Authentication
- WPA(2)-PSK Application Example
- WPA(2) with RADIUS Application Example
- Security Parameters Summary
- Setting up Your Computer’s IP Address
- Index
ZyXEL AG-120 User’s Guide
52 Chapter 4 ZyXEL Utility Configuration
Figure 27 Profile: Select a Channel
The following table describes the labels in this screen.
3 If you select Infrastructure network type in the first screen, select WEP, WPA-PSK,
WPA-RADIUS, WPA2-PSK, WPA2-RADIUS or RADIUS from the drop-down list
box to enable data encryption. If you select Ad-Hoc network type in the first screen, you
can only use WEP encryption method. Otherwise, select Disabled to allow the AG-120
to communicate with the access points or other peer wireless computers without any data
encryption and skip to step 5.
Table 12 Profile: Select a Channel
LABEL DESCRIPTION
Wireless Settings
Channel Select a channel number from the drop-down list box. To associate to an ad-hoc
network, you must use the same channel as the peer computer.