User Manual

ZyXEL AG-320 User’s Guide
50 Chapter 4 ZyXEL Utility Configuration
2 If you select the Infrastructure network type in the previous screen, skip to step 3. If you
select the Ad-Hoc network type in the previous screen, a screen displays as follows.
Select a channel number and click Next to continue.
Note: To associate to an ad-hoc network, you must use the same channel as the peer
computer.
Figure 27 Profile: Select a Channel
The following table describes the labels in this screen.
3 If you select Infrastructure network type in the first screen, select WEP, WPA-PSK,
WPA, WPA2-PSK, or WPA2 from the drop-down list box to enable data encryption. If
you select Ad-Hoc network type in the first screen, you can only use WEP encryption
method. Otherwise, select Disabled to allow the AG-320 to communicate with the access
points or other peer wireless computers without any data encryption and skip to step 5.
Scan Click Scan to search for available wireless devices within transmission range.
Select Select an available wireless device in the table and click Select to add it to this
profile.
Whenever you activate this profile, the AG-320 associates to the selected wireless
network only.
Table 12 Profile: Select a Channel
LABEL DESCRIPTION
Wireless Settings
Channel Select a channel number from the drop-down list box. To associate to an ad-hoc
network, you must use the same channel as the peer computer.
Table 11 Profile: Add a New Profile (continued)
LABEL DESCRIPTION