User's Manual Part 1

Chapter 8 Wireless LAN
AMG1202-T10A User’s Guide
110
8.5 The WPS Station Screen
Use this screen to set up a WPS wireless network using either Push Button Configuration (PBC) or
PIN Configuration.
Click Network > Wireless LAN > WPS Station. The following screen displays.
Figure 53 Network > Wireless LAN > WPS Station
The following table describes the labels in this screen.
8.6 The WDS Screen
An AP using the Wireless Distribution System (WDS) can function as a wireless network bridge
allowing you to wirelessly connect two wired network segments. The WDS screen allows you to
configure the ZyXEL Device to connect to two or more APs wirelessly when WDS is enabled.
Use this screen to set up your WDS (Wireless Distribution System) links between the ZyXEL Device
and other wireless APs. You need to know the MAC address of the peer device. Once the security
settings of peer sides match one another, the connection between devices is made.
Table 36 Network > Wireless LAN > WPS Station
LABEL DESCRIPTION
Push Button Click this to add another WPS-enabled wireless device (within wireless range of
the ZyXEL Device) to your wireless network. This button may either be a physical
button on the outside of device, or a menu button similar to the Push Button on
this screen.
Note: You must press the other wireless device’s WPS button within two minutes of
pressing this button.
Or input station's
PIN number
Enter the PIN of the device that you are setting up a WPS connection with and
click Start to authenticate and add the wireless device to your wireless network.
You can find the PIN either on the outside of the device, or by checking the
device’s settings.
Note: You must also activate WPS on that device within two minutes to have it
present its PIN to the ZyXEL Device.