User's Manual Part 1

Chapter 16 Remote Management
AMG1202-T10A User’s Guide
175
16.5.1 Configuring SNMP
To change your ZyXEL Device’s SNMP settings, click Advanced > Remote MGMT > SNMP tab.
The screen appears as shown.
Figure 93 Advanced > Remote MGMT > SNMP
The following table describes the labels in this screen.
Table 66 Advanced > Remote MGMT > SNMP
LABEL DESCRIPTION
SNMP
Server Port The SNMP agent listens on port 161 by default. If you change the SNMP server
port to a different number on the ZyXEL Device, for example 8161, then you must
notify people who need to access the ZyXEL Device SNMP agent to use the same
port.
Server Access Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Secured Client
IP Address
A secured client is a “trusted” computer that is allowed to access the SNMP agent
on the ZyXEL Device.
Select All to allow any computer to access the SNMP agent.
Choose Selected to just allow the computer with the IP address that you specify
to access the SNMP agent.
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and
GetNext requests from the management station. The default is public and allows
all requests.
Set Community Enter the Set Community, which is the password for incoming Set requests from
the management station. The default is public and allows all requests.
Trap Community Type the trap community, which is the password sent with each trap to the SNMP
manager. The default is public and allows all requests.
Trap Destination Type the IP address of the station to send your SNMP traps to.