User's Manual Part 1

Chapter 6 WAN Setup

AMG1202-T10A User’s Guide

6.3.2 Configuring More Connections Advanced Setup

Use this screen to edit your ZyXEL Device's advanced WAN settings. Click the Advanced Setup

button in the More Connections Edit screen. The screen appears as shown.

Figure 34 Network > WAN > More Connections: Edit: Advanced Setup

The following table describes the labels in this screen.

Back Click this to return to the previous screen without saving.

Apply Click this to save your changes.

Cancel Click this to restore your previously saved settings.

Advanced Setup Click this to display the More Connections Advanced Setup screen and

edit more details of your WAN setup.

Table 19 Network > WAN > More Connections: Edit (continued)

LABEL DESCRIPTION

Table 20 Network > WAN > More Connections: Edit: Advanced Setup

LABEL DESCRIPTION

ATM QoS

ATM QoS Type Select CBR (Continuous Bit Rate) to specify fixed (always-on) bandwidth

for voice or data traffic. Select UBR (Unspecified Bit Rate) for applications

that are non-time sensitive, such as e-mail. Select nrtVBR (Variable Bit

Rate-non Real Time) or rtVBR (Variable Bit Rate-Real Time) for bursty

traffic and bandwidth sharing with other applications.

Peak Cell Rate Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the

Peak Cell Rate (PCR). This is the maximum rate at which the sender can

send cells. Type the PCR here.

Sustain Cell Rate The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that

can be transmitted. Type the SCR, which must be less than the PCR. Note

that system default is 0 cells/sec.

Maximum Burst Size Maximum Burst Size (MBS) refers to the maximum number of cells that

can be sent at the peak rate. Type the MBS, which is less than 65535.

MTU