User's Guide Part 1

Chapter 8 Home Networking
AMG1302/AMG1202-TSeries User’s Guide
124
The following table describes the fields in this screen.
Table 30 Network Setting > Home Networking > LAN Setup
LABEL DESCRIPTION
LAN IP Setup
IP Address Enter the LAN IP address you want to assign to your AMG1302/AMG1202-TSeries in
dotted decimal notation, for example, 192.168.1.1 (factory default).
Subnet Mask Type the subnet mask of your network in dotted decimal notation, for example
255.255.255.0 (factory default). Your AMG1302/AMG1202-TSeries automatically
computes the subnet mask based on the IP Address you enter, so do not change this
field unless you are instructed to do so.
Dynamic Route
RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. Select the RIP version from RI P1 and RI P2 .
Direction
Use this field to control how much routing information the VDSL Router sends and
receives on the subnet. Select the RI P Dir e ct ion from N one, Both, I N Only and
OUT On ly.
Multicast IGMP (Internet Group Multicast Protocol) is a network-layer protocol used to establish
membership in a multicast group. The AMG1302/AMG1202-TSeries supports I GM P
v1 / I GM P v2 / I GM P v3 . Select N on e to disable it.
IGMP Snooping Select Enabled to activate IGMP Snooping. This allows the AMG1302/AMG1202-
TSeries to passively learn memberships in multicast groups. Otherwise, select
Disa ble d to deactivate it.
DHCP Server State
DHCP If set to Enable , your AMG1302/AMG1202-TSeries can assign IP addresses, an IP
default gateway and DNS servers to Windows 95, Windows NT and other systems that
support the DHCP client.
If set to Disable , the DHCP server will be disabled.
If set to DHCP Re lay, the AMG1302/AMG1202-TSeries acts as a surrogate DHCP
server and relays DHCP requests and responses between the remote server and the
clients. Enter the IP address of the actual, remote DHCP server in the Re m ote D H CP
Serve r field in this case.
When DHCP is used, the following items need to be set:
IP Addressing Values
Beginning IP Address This field specifies the first of the contiguous addresses in the IP address pool.
Pool Size This field specifies the size, or count of the IP address pool.
DHCP Server Lease Time
Lease Time This field specifies the lease time in seconds of an IP address assigned by the DHCP
server.
DNS Values
DNS
Select D yna m ic to have the AMG1302/AMG1202-TSeries pass a DNS (Domain Name
System) server IP address to the DHCP clients.
Select St a t ic and enter the DNS server IP address(es) in the fields below, if you know
the IP address.
DNS Server 1/2 Enter the IP address of your primary/secondary DNS server.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.
Advanced Setup Click this to display the Advan ce d LAN Se t u p screen and edit more details of your
LAN setup.