User's Guide Part 1

Chapter 1 Introduction

AMG1302/AMG1202-TSeries User’s Guide

1.6 Using the WPS Button

You can also use the W PS button to quickly set up a secure wireless connection between the

AMG1302/AMG1202-TSeries and a WPS-compatible client by adding one device at a time.

To activate WPS:

1 Make sure the POW ER LED is on and not blinking.

2 Press the W PS button for 1-5 seconds and release it. See below for WPS button location.

3 Press the WPS button on another WPS-enabled device within range of the AMG1302/AMG1202-

TSeries. The W PS LED should flash while the AMG1302/AMG1202-TSeries sets up a WPS

connection with the other wireless device.

4 Once the connection is successfully made, the W PS LED shines green.

(WPS/WLAN)

Green On The wireless network is activated.

Blinking The AMG1302/AMG1202-TSeries is communicating with other

wireless clients.

Green Blinking The AMG1302/AMG1202-TSeries is setting up a WPS connection.

Off The wireless network is not activated.

(DSL)

Green On The DSL line is up.

Blinking The AMG1302/AMG1202-TSeries is initializing the DSL line.

Off The DSL line is down.

(INTERNET)

Green On The AMG1302/AMG1202-TSeries has an IP connection but no

traffic.

Your device has a WAN IP address (either static or assigned by a

DHCP server), PPP negotiation was successfully completed (if

used) and the DSL connection is up.

Blinking The AMG1302/AMG1202-TSeries is sending or receiving IP traffic.

Red On The AMG1302/AMG1202-TSeries attempted to make an IP

connection but failed. Possible causes are no response from a

DHCP server, no PPPoE response, PPPoE authentication failed.

Off The AMG1302/AMG1202-TSeries does not have an IP connection.

Table 1 LED Descriptions

LED COLOR STATUS DESCRIPTION

WPS