User's Guide Part 1

Chapter 1 Introduction

AMG1302/AMG1202-TSeries User’s Guide

1.7 The RESET Button

If you forget your password or cannot access the web configurator, you will need to use the RESET

button at the back of the device to reload the factory-default configuration file. This means that you

will lose all configurations that you had previously and the user name and password will be reset to

the default.

1.7.1 Using the Reset Button

1 Make sure the POW ER LED is on (not blinking).

2 To set the device back to the factory default settings, press the RESET button for ten seconds or

until the POW ER LED begins to blink and then release it. When the POW ER LED begins to blink,

the defaults have been restored and the device restarts.

1.8 Ways to Manage the AMG1302/AMG1202-TSeries

Use any of the following methods to manage the AMG1302/AMG1202-TSeries.

• Web Configurator. This is recommended for everyday management of the AMG1302/AMG1202-

TSeries using a (supported) web browser.

• FTP for firmware upgrades and configuration backup/restore.