User's Guide Part 1

Chapter 6 Broadband
AMG1302/AMG1202-TSeries User’s Guide
80
The following table describes the labels in this screen.
Table 12 Network Setting > Broadband > Internet Connection: Advanced Setup
LABEL DESCRIPTION
RIP Direction RIP (Routing Information Protocol) allows a router to exchange routing information
with other routers. Use this field to control how much routing information the
AMG1302/AMG1202-TSeries sends and receives on the subnet.
Select the RIP direction from None, Bot h, I n Only and Ou t Only.
RIP Version This field is not configurable if you select N one in the RI P D ir e ct ion field.
Select the RIP version from RI P- 1 , RI P2 - B and RI P2 - M .
Multicast Multicast packets are sent to a group of computers on the LAN and are an alternative
to unicast packets (packets sent to one computer) and broadcast packets (packets
sent to every computer).
Internet Group Multicast Protocol (IGMP) is a network-layer protocol used to establish
membership in a multicast group. The AMG1302/AMG1202-TSeries supports I GM P-
v1 , I GM P- v2 and I GM P- v3 . Select N one to disable it.
MLD Proxy Select the version of MLD proxy (v1 or v2) to have the AMG1302/AMG1202-TSeries
act as for this connection. This allows the AMG1302/AMG1202-TSeries to get
subscription information and maintain a joined member list for each multicast group.
It can reduce multicast traffic significantly. Select N on e to turn off MLD proxy.
ATM QoS
ATM QoS Type Select CBR (Continuous Bit Rate) to specify fixed (always-on) bandwidth for voice or
data traffic. Select UBR W it h PCR (Unspecified Bit Rate) for applications that are
non-time sensitive, such as e-mail. Select Re a lt im e VBR (real-time Variable Bit
Rate) type for applications with bursty connections that require closely controlled
delay and delay variation. Select N on Re a lt im e VBR (non real-time Variable Bit
Rate) type for connections that do not require closely controlled delay and delay
variation.
Peak Cell Rate Divide the DSL line rate (bps) by 424 (the size of an ATM cell) to find the Peak Cell
Rate (PCR). This is the maximum rate at which the sender can send cells. Type the
PCR here.
Sustain Cell Rate The Sustain Cell Rate (SCR) sets the average cell rate (long-term) that can be
transmitted. Type the SCR, which must be less than the PCR. Note that system default
is 0 cells/sec.
Maximum Burst
Size
Maximum Burst Size (MBS) refers to the maximum number of cells that can be sent at
the peak rate. Type the MBS, which is less than 65535.
PPPoE Passthrough If encapsulation type is PPPoE, select this to enable PPPoE Passthrough. In addition to
the Device’s built-in PPPoE client, you can select this to allow hosts on the LAN to use
PPPoE client software on their computers to connect to the ISP via the device. Each
host can have a separate account and a public WAN IP address.
MTU
MTU The Maximum Transmission Unit (MTU) defines the size of the largest packet allowed
on an interface or connection. Enter the MTU in this field.
For ENET ENCAP, the MTU value is 1500.
For PPPoE, the MTU value is 1492.
For PPPoA and RFC 1483, the MTU is 65535.