User's Guide Part 2

Chapter 25 Remote Management
AMG1302/AMG1202-TSeries User’s Guide
232
Figure 124 Maintenance > RemoteMGMT > SSH
The following table describes the labels in this screen.
25.8.1 SSH Example
This section shows an example using a graphical interface SSH client program to remotely access
the ZyXEL Device. The configuration and connection steps are similar for most SSH client programs.
Refer to your SSH client program user’s guide.
1 Enter the IP address and port number. Select SSH.
Table 91 Maintenance > RemoteMGMT > SSH
LABEL DESCRIPTION
Server Port This displays the service port number for accessing the AMG1302/AMG1202-TSeries. If
the number is grayed out, it is not editable.
Server Access Select the interface(s) through which a computer may access the AMG1302/AMG1202-
TSeries using this service.
Note: It is recommended if you are allowing WAN access even temporarily to change the
default password (in Maintenance > User Account). To allow access from the
WAN, you will need to configure a WAN to Router firewall rule. See Firewall Section
on page 173 for information on configuring firewall rules.
Secured Client IP
Address
A secured client is a “trusted” computer that is allowed to communicate with the
AMG1302/AMG1202-TSeries using this service.
Select All to allow any computer to access the AMG1302/AMG1202-TSeries using this
service.
Choose Range to just allow the computer(s) with an IP address in the range that you
specify to access the AMG1302/AMG1202-TSeries using this service.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.