User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 8 Home Networking
AMG1302/AMG1202-TSeries User’s Guide
127
When you use IP alias, you can also configure firewall rules to control access to the LAN's logical
network (subnet).
8.5.1 Configuring the LAN IP Alias Screen
Use this screen to change your AMG1302/AMG1202-TSeries’s IP alias settings. Click Network
Setting > Home Networking > IP Alias to open the following screen.
Figure 52 Network Setting > Home Networking > IP Alias
The following table describes the labels in this screen.
8.6 The IPv6 LAN Setup Screen
Use this screen to configure the IPv6 settings for your AMG1302/AMG1202-TSeries’s LAN interface.
See Appendix E on page 295 for background information about IPv6.
Table 34 Network Setting > Home Networking > IP Alias
LABEL DESCRIPTION
IP Alias Select Enable to configure a LAN network for the AMG1302/AMG1202-TSeries.
IP Address Enter the IP address of your AMG1302/AMG1202-TSeries in dotted decimal notation.
IP Subnet Mask Your AMG1302/AMG1202-TSeries will automatically calculate the subnet mask based on
the IP address that you assign. Unless you are implementing subnetting, use the subnet
mask computed by the AMG1302/AMG1202-TSeries.
Apply Click this to save your changes.
Cancel Click this to restore your previously saved settings.