User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 9 Static Route
AMG1302/AMG1202-TSeries User’s Guide
136
9.1.1 What You Can Do in the Static Route Screens
•Use the Static Route screens (Section 9.2 on page 136) to view and configure IP static routes
on the AMG1302/AMG1202-TSeries.
•Use the IPv6 Static Route screens (Section 9.3 on page 137) to view and configure IPv6 static
routes on the AMG1302/AMG1202-TSeries.
9.2 The Static Route Screen
Use this screen to view the static route rules. Click Network Setting > Static Route to open the
Static Route screen.
Figure 56 Network Setting > Static Route
The following table describes the labels in this screen.
9.2.1 Static Route Add/Edit
Use this screen to add or edit a static route. Click Add new Static Route Entry in the Routing
screen or the Edit icon next to the static route you want to edit. The screen shown next appears.
Table 36 Network Setting > Static Route
LABEL DESCRIPTION
Add new static
route
Click this to configure a new static route.
# This is the number of an individual static route.
Destination IP This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Subnet Mask This parameter specifies the IP network subnet mask of the final destination.
Metric This is the number of transmission hops between this AMG1302/AMG1202-TSeries and
the destination.
Modify Click the Edit icon to go to the screen where you can set up a static route on the
AMG1302/AMG1202-TSeries.
Click the Delete icon to remove a static route from the AMG1302/AMG1202-TSeries. A
window displays asking you to confirm that you want to delete the route.