User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 10 Quality of Service (QoS)
AMG1302/AMG1202-TSeries User’s Guide
143
10.4 The Class Setup Screen
Use this screen to add, edit or delete QoS classifiers. A classifier groups traffic into data flows
according to specific criteria such as the source address, destination address, source port number,
destination port number or incoming interface. For example, you can configure a classifier to select
traffic from the same protocol port (such as Telnet) to form a flow.
You can give different priorities to traffic that the AMG1302/AMG1202-TSeries forwards out through
the WAN interface. Give high priority to voice and video to make them run more smoothly.
Similarly, give low priority to many large file downloads so that they do not reduce the quality of
other applications.
Click Network Setting > QoS > Class Setup to open the screen as shown next.
Figure 64 Network Setting > QoS > Class Setup
The following table describes the labels in this screen.
10.4.1 Class Setup Add/Edit
Click Add new Classifier in the Network Setting > QoS > Class Setup screen or click the Edit
icon next to a class, the screen appears as shown next.
Table 43 Network Setting > QoS > Class Setup
LABEL DESCRIPTION
Add new Classifier Click this to create a new classifier.
Index This is the index number of the entry.
Status This field displays whether the classifier is active or not. A yellow bulb signifies that this
classifier is active. A gray bulb signifies that this classifier is not active.
From Interface This shows the interface from which traffic of this class should come.
Classification
Criteria
This shows criteria specified in this classifier, for example the type and the source MAC
address of traffic that matches this classifier.
DSCP Mark This is the DSCP number added to traffic of this classifier.
802.1P/1Q Mark This is the IEEE 802.1p priority level and 802.1Q VLAN tag assigned to traffic of this
classifier.
To Queue This is the name of the queue in which traffic of this classifier is put.
Modify Click the Edit icon to edit the classifier.
Click the Delete icon to delete an existing classifier. Note that subsequent rules move up
by one when you take this action.