User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
AMG1302/AMG1202-TSeries User’s Guide 161
CHAPTER 12
Port Binding
12.1 Overview
This chapter describes how to configure the port binding settings.
Port binding allows you to aggregate port connections into logical groups. You may bind WAN PVCs
to Ethernet ports and WLANs to specify how traffic is forwarded. Different ATM QoS settings can be
specified for each WAN PVC to meet bandwidth requirements for the type of traffic to be
transferred.
For example, three port binding groups could be created on the device (R1) for three different WAN
PVC connections. The first PVC (PVC0) is for non time-sensitive data traffic. The second and third
PVCs (PVC1 and PVC2) are for time sensitive Media-On-Demand (MOD) video traffic and VoIP
traffic, respectively.
Figure 74 Port Binding Groups
S2
S1
R1
R1
R1
MOD
VoIP
Data
PVC0
PVC2
PVC1