User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 3 Internet / Wireless Setup Wizard
AMG1302/AMG1202-TSeries User’s Guide
31
The following table describes the fields in this screen.
Note: Virtual Path Identifier (VPI) and Virtual Channel Identifier (VCI) define a virtual circuit.
Figure 11 Internet Connection with ENET ENCAP
Table 3 Internet Access Wizard Setup: IPoA Configuration
LABEL DESCRIPTION
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation
drop-down list box: IPoA, ENET ENCAP, PPPoA, or PPPoE.
Multiplex Select the multiplexing method used by your ISP from the Multiplex
drop-down list box either VC-based or LLC-based.
VPI Enter the Virtual Path Identifier (VPI) assigned to you. This field may
already be configured.
VCI Enter the Virtual Channel Identifier (VCI) assigned to you. This field may
already be configured.
IP Address Enter the IP address of the AMG1302/AMG1202-TSeries.
Default
Gateway
Enter the default gateway of the ZyXEL Device.
Primary DNS
Server
Enter the primary DNS server IP address for the AMG1302/AMG1202-
TSeries.
Secondary
DNS Server
Enter the secondary DNS server IP address for the AMG1302/AMG1202-
TSeries.
Back Click this to return to the previous screen without saving.
Next Click this to continue to the next wizard screen. The next wizard screen
you see depends on what protocol you chose above.
Exit Click this to close the wizard screen without saving.