User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 3 Internet / Wireless Setup Wizard
AMG1302/AMG1202-TSeries User’s Guide
32
The following table describes the fields in this screen.
Table 4 Internet Connection with ENET ENCAP
LABEL DESCRIPTION
Encapsulation Select the encapsulation type your ISP uses from the Encapsulation
drop-down list box: IPoA, ENET ENCAP, PPPoA, or PPPoE.
Multiplex Select the multiplexing method used by your ISP from the Multiplex
drop-down list box either VC-based or LLC-based.
VPI Enter the Virtual Path Identifier (VPI) assigned to you. This field may
already be configured.
VCI Enter the Virtual Channel Identifier (VCI) assigned to you. This field may
already be configured.
Select Yes to enter specific IP information from your Internet service provider. Enter
your Internet access information exactly as your service provider gave it to you.
IP Address Enter the IP address of the AMG1302/AMG1202-TSeries.
Subnet Mask Enter the subnet mask in dotted decimal notation.
Refer to the appendix to calculate a subnet mask if you are implementing
subnetting.
Default
Gateway
You must specify a gateway IP address (supplied by your ISP) when you
use ENET ENCAP in the Encapsulation field in the previous screen.
Primary DNS
Server
Enter the primary DNS server IP address for the AMG1302/AMG1202-
TSeries.
Secondary
DNS Server
Enter the secondary DNS server IP address for the AMG1302/AMG1202-
TSeries.
Back Click this to return to the previous screen without saving.
Apply Click this to save your changes.
Exit Click this to close the wizard screen without saving.