User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
AMG1302/AMG1202-TSeries User’s Guide 37
CHAPTER 4
Tutorials
4.1 Overview
This chapter shows you how to use the AMG1302/AMG1202-TSeries’s various features.
• Setting Up Your DSL Connection, see page 37
• IPv6 Address Configuration, see page 39
• Setting Up a Secure Wireless Network, see page 40
• Configuring the MAC Address Filter for Restricting Wireless Internet Access, see page 47
• Setting Up NAT Forwarding for a Game Server, see page 48
• Setting Up NAT Forwarding for a Game Server, see page 48
• Configuring Firewall Rules to Allow a Specified Service, see page 50
• Configuring Static Route for Routing to Another Network, see page 53
• Port Binding Configuration, see page 55
• Configuring QoS to Prioritize Traffic, see page 59
• Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS, see page 62
4.2 Setting Up Your DSL Connection
This tutorial shows you how to set up your Internet connection using the web configurator.
If you connect to the Internet through a DSL connection, use the information from your Internet
Service Provider (ISP) to configure the AMG1302/AMG1202-TSeries. Do the following steps:
1 Connect the AMG1302/AMG1202-TSeries properly. Refer to the Quick Start Guide for details on the
AMG1302/AMG1202-TSeries’s hardware connection.
2 Connect one end of a DSL cable to the DSL port of your AMG1302/AMG1202-TSeries. The other end
should be connected to the DSL port in your house or a DSL router/modem provided by your ISP.
3 Connect one end of Ethernet cable to an Ethernet port on the AMG1302/AMG1202-TSeries and the
other end to a computer that you will use to access the web configuration.
4 Connect the AMG1302/AMG1202-TSeries to a power source, turn it on and wait for the POWER
LED to become a steady green.