User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 4 Tutorials
AMG1302/AMG1202-TSeries User’s Guide
40
In the Network Setting > Broadband screen’s IPv6 Address configuration section, select
Obtain an IP Address Automatically. In the DHCP IPv6 field select DHCP to obtain an IPv6
address from a DHCPv6 server. In the DHCP PD field select Enable to have the AMG1302/
AMG1202-TSeries pass the WAN prefix to LAN hosts. The LAN hosts can then use the prefix to
generate their IPv6 addresses.
4.4 Setting Up a Secure Wireless Network
Thomas wants to set up a wireless network so that he can use his notebook to access the Internet.
In this wireless network, the AMG1302/AMG1202-TSeries serves as an access point (AP), and the
notebook is the wireless client. The wireless client can access the Internet through the AP.
Thomas has to configure the wireless network settings on the AMG1302/AMG1202-TSeries. Then he
can set up a wireless network using WPS (Section 4.4.2 on page 41) or manual configuration
(Section 4.4.3 on page 45).
4.4.1 Configuring the Wireless Network Settings
This example uses the following parameters to set up a wireless network. In the client, choose the
AP with the SSID configured here. When prompted for a key, use the Pre-Shared Key configured
here.
IPv6
IPv6
IPv6
SSID SecureWirelessNetwork
Security Mode WPA2-PSK
Pre-Shared Key DoNotStealMyWirelessNetwork
802.11 Mode 802.11b+g+n