User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 4 Tutorials
AMG1302/AMG1202-TSeries User’s Guide
41
1 Click Network Setting > Wireless to open the General screen. Configure the screen using the
provided parameters (see page 40). Click Apply.
2 Click Network Setting > Wireless > Advanced and make sure 802.11b+g+n is selected in the
802.11 Mode field. Click Apply.
Thomas can now use the WPS feature to establish a wireless connection between his notebook and
the AMG1302/AMG1202-TSeries (see Section 4.4.2 on page 41). He can also use the notebook’s
wireless client to search for the AMG1302/AMG1202-TSeries (see Section 4.4.3 on page 45).
4.4.2 Using WPS
This section shows you how to set up a wireless network using WPS. WPS is a way to automatically
set up a secure wireless network connection between an AP and a notebook. Limitations of using
WPS are that is must be done two devices at a time and within two minutes. It uses the AMG1302/
EXAMPLE