User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 4 Tutorials
AMG1302/AMG1202-TSeries User’s Guide
42
AMG1202-TSeries as the AP and ZyXEL NWD210N as the wireless client which connects to the
notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter
or PCMCIA card).
There are two WPS methods to set up the wireless client settings:
• Push Button Configuration (PBC) - simply press a button. This is the easier of the two
methods.
• PIN Configuration - configure a Personal Identification Number (PIN) on the AMG1302/
AMG1202-TSeries. A wireless client must also use the same PIN in order to download the wireless
network settings from the AMG1302/AMG1202-TSeries.
Push Button Configuration (PBC)
1 Make sure that your AMG1302/AMG1202-TSeries is turned on and your notebook is within the cover
range of the wireless signal.
2 Make sure that you have installed the wireless client driver and utility in your notebook.
3 Make sure wireless LAN is enabled and the wireless security mode is set to WPA-PSK2 or No
Security in the Network Setting > Wireless > General screen.
4 In the wireless client utility, go to the WPS setting page. Enable WPS and press the WPS button
(Start or WPS button).
5 Push and hold the WPS button on the AMG1302/AMG1202-TSeries for 1-2 seconds. Alternatively,
you may log into AMG1302/AMG1202-TSeries’s web configuration, enable WPS and click the WPS
button in the Network Setting > Wireless > WPS screen.
Note: It doesn’t matter which button (on the client or the AMG1302/AMG1202-TSeries) is
pressed first. You must press the second button within two minutes of pressing the
first one.
The AMG1302/AMG1202-TSeries sends the proper configuration settings to the wireless client. This
may take up to two minutes. The wireless client is then able to communicate with the AMG1302/
AMG1202-TSeries securely.