User's Manual

Chapter 6 Broadband
AMG1302/AMG1202-TSeries User’s Guide
78
VCI This option is available if you select Router in the Mode field.
The valid range for the VCI is 32 to 65535 (0 to 31 is reserved for local management
of ATM traffic). Enter the VCI assigned to you.
Enable VLAN This option is available if you select Ethernet(ETH1) in the Line->Type field.
The AMG1302/AMG1202-TSeries supports Ether WAN function: DSL users must
connect an RJ11 cable to the DSL port (Default), while EtherWAN users must connect
an RJ45 cable into LAN port 1.
802.1Q VLAN ID The valid range for the VLAN ID (as assinged by your provider) is 5 to 4094.
IP Address
Obtain an IP Address
Automatically
This option is available if you select Router in the Mode field.
A static IP address is a fixed IP that your ISP gives you. A dynamic IP address is not
fixed; the ISP assigns you a different one each time you connect to the Internet.
Select Obtain an IP Address Automatically if you have a dynamic IP address;
otherwise select Static IP Address and type your ISP assigned IP address in the IP
Address field and a gateway IP address (supplied by your ISP) below.
DNS Server - This section is not available when you select Bridge in the Mode field.
Obtain DNS info
Automatically
Select this to have the AMG1302/AMG1202-TSeries get the DNS server addresses
from the ISP automatically.
Use the following
Static DNS IP Address
Select this to have the AMG1302/AMG1202-TSeries use the DNS server addresses
you configure manually.
Primary DNS
Server
Enter the first DNS server address assigned by the ISP.
Secondary DNS
Server
Enter the second DNS server address assigned by the ISP.
IPv6 Address
Obtain an IP Address
Automatically
Select this option if you want to have the AMG1302/AMG1202-TSeries use the IPv6
prefix from the connected router’s Router Advertisement (RA) to generate an IPv6
address.
DHCP IPv6 Select DHCP if you want to obtain an IPv6 address from a DHCPv6 server.
The IP address assigned by a DHCPv6 server has priority over the IP address
automatically generated by the AMG1302/AMG1202-TSeries using the IPv6 prefix
from an RA.
Select SLAAC (Stateless address autoconfiguration) to have the AMG1302/AMG1202-
TSeries use the prefix to automatically generate a unique IP address that does not
need to be maintained by a DHCP server.
Select Auto to have the AMG1302/AMG1202-TSeries indicate to hosts for IPv6
address generation depending on the M/O (Managed/Other) flag values in the router
advertisements sending to hosts.
• If M flag is 1, the AMG1302/AMG1202-TSeries will indicate to hosts to obtain
network settings (such as WAN IP, LAN prefix and DNS settings) through DHCPv6.
• If M flag is 0, the AMG1302/AMG1202-TSeries will check O flag.
• If O flag is 1, the AMG1302/AMG1202-TSeries will indicate to hosts to obtain DNS
information and LAN prefix through DHCPv6.
• If O flag is 0, the AMG1302/AMG1202-TSeries will not get information through
DHCPv6.
DHCP PD Select Enable to use DHCP PD (Prefix Delegation) to allow the AMG1302/AMG1202-
TSeries to pass the IPv6 prefix information to its LAN hosts. The hosts can then use
the prefix to generate their IPv6 addresses.
Table 11 Network Setting > Broadband > Internet Connection (continued)
LABEL DESCRIPTION