User's Manual
Table Of Contents
- Contents Overview
- Table of Contents
- Introduction
- Introducing the Web Configurator
- Internet / Wireless Setup Wizard
- Tutorials
- 4.1 Overview
- 4.2 Setting Up Your DSL Connection
- 4.3 IPv6 Address Configuration
- 4.4 Setting Up a Secure Wireless Network
- 4.5 Configuring the MAC Address Filter for Restricting Wireless Internet Access
- 4.6 Setting Up NAT Forwarding for a Game Server
- 4.7 Configuring Firewall Rules to Allow a Specified Service
- 4.8 Configuring Static Route for Routing to Another Network
- 4.9 Port Binding Configuration
- 4.10 Configuring QoS to Prioritize Traffic
- 4.11 Access the AMG1302/AMG1202-TSeries from the Internet Using DDNS
- Connection Status and System Info Screens
- Broadband
- Wireless LAN
- Home Networking
- Static Route
- Quality of Service (QoS)
- Network Address Translation (NAT)
- Port Binding
Chapter 7 Wireless LAN
AMG1302/AMG1202-TSeries User’s Guide
97
The WPA security mode is a security subset of WPA2. It requires the presence of a RADIUS server
on your network in order to validate user credentials. This encryption standard is slightly older than
WPA2 and therefore is more compatible with older devices.
Click Network Setting > Wireless to display the General screen. Select More Secure as the
security level. Then select WPA or WPA2 from the Security Mode list.
Figure 31 Wireless > General: More Secure: WPA(2)
The following table describes the labels in this screen.
Table 19 Wireless > General: More Secure: WPA(2)
LABEL DESCRIPTION
Security Level Select More Secure to enable WPA(2) data encryption.
Security Mode Choose WPA or WPA2 from the drop-down list box.
Authentication Server
IP Address Enter the IP address of the external authentication server in dotted decimal notation.
Port Number Enter the port number of the external authentication server.
You need not change this value unless your network administrator instructs you to do
so with additional information.
Shared Secret Enter a password (up to 31 alphanumeric characters) as the key to be shared between
the external authentication server and the AMG1302/AMG1202-TSeries.
The key must be the same on the external authentication server and your AMG1302/
AMG1202-TSeries. The key is not sent over the network.
more.../hide more Click more... to show more fields in this section. Click hide more to hide them.
ReAuthentication
Timer
Enter how often the external authentication server requires a connected wireless client
to reauthenticate itself to the server again.
Network Re-auth
Interval
Specify how often wireless stations have to resend user names and passwords in order
to stay connected.
This field is available only when you select WPA2 as security mode. If wireless station
authentication is done using a RADIUS server, the reauthentication timer on the
RADIUS server has priority.
WPA Compatible This field is only available for WPA2. Select this if you want the AMG1302/AMG1202-
TSeries to support WPA and WPA2 simultaneously.