User Guide Part 1

Chapter 1 Introduction

AMG1312-T Series User’s Guide

1.6 Using the WPS Button

You can also use the W PS button to quickly set up a secure wireless connection between the

AMG1312-T Series and a WPS-compatible client by adding one device at a time.

To activate WPS:

1 Make sure the POW ER LED is on and not blinking.

2 Press the W PS button for 1-5 seconds and release it. See below for WPS button location.

(WLAN)

Green On The wireless network is activated.

Blinking The AMG1312-T Series is communicating with wireless clients.

Off The wireless network is not activated.

(WPS)

Green On WPS is ready.

Blinking The AMG1312-T Series is setting up a WPS connection.

Off WPS is disabled or has failed.

(DSL)

Green On The DSL line is up.

Blinking The AMG1312-T Series is initializing the DSL line.

Off The DSL line is down.

(INTERNET)

Green On The AMG1312-T Series has an IP connection but no traffic.

Your device has a WAN IP address (either static or assigned by a

DHCP server), PPP negotiation was successfully completed (if

used) and the DSL connection is up.

Blinking The AMG1312-T Series is sending or receiving IP traffic.

Red On The AMG1312-T Series attempted to make an IP connection but

failed. Possible causes are no response from a DHCP server, no

PPPoE response, PPPoE authentication failed.

Off The AMG1312-T Series does not have an IP connection.

USB

Green On The AMG1312-T Series recognizes a USB connection through the

USB slot.

Blinking The AMG1312-T Series is sending/receiving data to /from the USB

device connected to it.

Off The AMG1312-T Series does not detect a USB connection through

the USB slot.

Table 1 LED Descriptions (continued)

LED COLOR STATUS DESCRIPTION