User Guide Part 2
Table Of Contents
- Dynamic DNS Setup
- Filters
- Firewall
- Parental Control
- Certificate
- Logs
- Traffic Status
- User Account
- TR-069 Client
- System Settings
- Firmware Upgrade
- Backup/Restore
- Remote Management
- Diagnostic
- Troubleshooting
- Setting up Your Computer’s IP Address
- IP Addresses and Subnetting
- Pop-up Windows, JavaScripts and Java Permissions
- Wireless LANs
- IPv6
- Services
- Legal Information
- Index
AMG1312-T Series User’s Guide 224
CHAPTER 27
Troubleshooting
This chapter offers some suggestions to solve problems you might encounter. The potential
problems are divided into the following categories.
• Power, Hardware Connections, and LEDs
• AMG1312-T Series Access and Login
• Internet Access
27.1 Power, Hardware Connections, and LEDs
The AMG1312-T Series does not turn on. None of the LEDs turn on.
1 Make sure the AMG1312-T Series is turned on.
2 Make sure you are using the power adaptor or cord included with the AMG1312-T Series.
3 Make sure the power adaptor or cord is connected to the AMG1312-T Series and plugged in to an
appropriate power source. Make sure the power source is turned on.
4 Turn the AMG1312-T Series off and on.
5 If the problem continues, contact the vendor.
One of the LEDs does not behave as expected.
1 Make sure you understand the normal behavior of the LED. Section 1.5 on page 16
2 Check the hardware connections.
3 Inspect your cables for damage. Contact the vendor to replace any damaged cables.
LABEL DESCRIPTION
WPS LED Green: successful connection
Off: connection failure
WIFI LED Green: WIFI active
Off: WIFI inactive