Installation Guide
Table Of Contents
- Copyright
- Limited Warranty
- Information for Canadian Users
- Federal Communications Commission (FCC) Interference Statement
- Customer Support
- List of Figures
- List of Tables
- Preface
- Wireless Network Basics
- Disable Windows XP Configuration Tool
- Using the Wireless LAN Utility
- Wireless LAN Security
- Advanced Configuration
- Removing and Upgrading the WLAN Utility
- Troubleshooting
- Index
Wireless LAN Utility
vi FCC Statement
The end user should NOT be provided any instructions on how to remove or install the device.
End Product Labeling
This transmitter module is authorized only for use in devices where the antenna may be installed such that
20 cm may be maintained between the antenna and users (for example access points, routers, wireless
ASDL modems, and similar equipment). The final end product must be labeled in a visible area with the
following: Contains TX FCC ID: I88B-120
IMPORTANT NOTE
1. In the event that these conditions can not be met (for example certain laptop configurations or co-
location with another transmitter), then the FCC authorization is no longer considered valid and the
FCC ID can not be used on the final product. In these circumstances, the OEM integrator will be
responsible for re-evaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
2. To comply with FCC RF exposure compliance requirements, the antenna used for this transmitter must
be installed to provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter."
Certifications
Refer to the product page at OEM web site.