User's Guide

Chapter 19 Remote Management
EMG1302-R10A User’s Guide
139
19.5 The Telnet Screen
You can use Telnet to access the EMG1302-R10A’s command line interface. Specify which interfaces
allow Telnet access and from which IP address the access can come.
Click Configuration > Management > Remote MGMT > Telnet to display the screen as shown.
Figure 77 Configuration > Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
Access Status Select the interface(s) through which a computer may access the EMG1302-R10A using
this HTTP service.
Secured Client IP
Address
Select All to allow all computers to access the EMG1302-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG1302-R10A.
Apply Click Apply to save your changes back to the EMG1302-R10A.
Cancel Click Cancel to exit this screen without saving.
Table 56 Configuration > Management > Remote MGMT > WWW (continued)
LABEL DESCRIPTION
Table 57 Configuration > Management > Remote MGMT > Telnet
LABEL DESCRIPTION
Port You may change the server port number for a service if needed. However you must use
the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the EMG1302-R10A using
this service.
Secured Client IP
Address
Select All to allow all computers to access the EMG1302-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG1302-R10A.
Apply Click Apply to save your changes back to the EMG1302-R10A.
Cancel Click Cancel to exit this screen without saving.