User`s guide

Chapter 24 Maintenance
EMG2926-Q10A User’s Guide
152
The following table describes the labels on this screen.
Note: If you uploaded the default configuration file you may need to change the IP
address of your computer to be in the same subnet as that of the default
EMG2926-Q10A IP address (192.168.0.1).
24.6 Restart Screen
System restart allows you to reboot the EMG2926-Q10A without turning the power off.
Click Maintenance > Restart to open the following screen.
Figure 106 Maintenance > Restart
Click Restart to have the EMG2926-Q10A reboot. This does not affect the EMG2926-Q10A's
configuration.
24.7 Language Screen
Use this screen to change the language for the Web Configurator.
Table 73 Maintenance > Backup/Restore
LABEL DESCRIPTION
Backup Click Backup to save the EMG2926-Q10A’s current configuration to your computer.
File Path Type in the location of the file you want to upload in this field or click Browse... to find it.
Choose File Click Choose File to find the file you want to upload. Remember that you must
decompress compressed (.ZIP) files before you can upload them.
Upload Click Upload to begin the upload process.
Note: Do not turn off the EMG2926-Q10A while configuration file upload is in progress.
After you see a “configuration upload successful” screen, you must then wait one minute
before logging into the EMG2926-Q10A again. The EMG2926-Q10A automatically restarts
at this time causing a temporary network disconnect.
If you see an error screen, click Back to return to the Backup/Restore screen.
Reset Pressing the Reset button in this section clears all user-entered configuration information
and returns the EMG2926-Q10A to its factory defaults.
You can also press the RESET button on the rear panel to reset the factory defaults of your
EMG2926-Q10A. Refer to the chapter about introducing the Web Configurator for more
information on the RESET button.