User's Manual
Table Of Contents
- EMG2926-Q10A
- User’s Guide
- Technical Reference
- Monitor
- WAN
- Wireless LAN
- LAN
- DHCP Server
- NAT
- DDNS
- Static Route
- Firewall
- Content Filtering
- Parental Control
- IPv6 Firewall
- StreamBoost Management
- Remote Management
- Universal Plug-and-Play (UPnP)
- USB Media Sharing
- Port Configuration
- Maintenance
- Troubleshooting
- Legal Information
- Index
Chapter 12 LAN
EMG2926-Q10A User’s Guide
110
Figure 72 LAN and WAN IP Addresses
The LAN parameters of the EMG2926-Q10A in router mode are preset in the factory with the
following values:
•
IPv4 address of 192.168.0.1 with subnet mask of 255.255.255.0 (24 bits)
• DHCP server enabled with 32 client IP addresses starting from
192.168.0.33.
These parameters should work for the majority of installations. If your ISP gives you explicit DNS
server address(es), read the embedded Web Configurator help regarding what fields need to be
configured.
12.3.1 IP Alias
IP alias allows you to partition a physical network into different logical networks over the same
Ethernet interface. The EMG2926-Q10A supports three logical LAN interfaces via its single physical
Ethernet interface with the EMG2926-Q10A itself as the gateway for each LAN network.
12.4 LAN IP Screen
Use this screen to change the
IPv4 address for your EMG2926-Q10A. Click N e tw ork > LAN > I P.
Figure 73 Network > LAN > IP
The following table describes the labels in this screen.
Table 44 Network > LAN > IP
LABEL DESCRIPTION
IP Address Type the IP address of your EMG2926-Q10A in dotted decimal notation.