User's Manual

Chapter 16 Static Route
EMG2926-Q10A User’s Guide
132
Figure 89 Network > Static Route
The following table describes the labels in this screen.
16.2.1 Add/Edit Static Route
Click the Add Sta tic Rout e button or a rule’s Edit icon in the Sta t ic Rout e screen. Use this screen
to configure the required information for a static route.
Figure 90 Network > Static Route: Add/Edit
Table 56 Network > Static Route
LABEL DESCRIPTION
Add Static Route Click this to create a new rule.
# This is the number of an individual static route.
Status This field indicates whether the rule is active (yellow bulb) or not (gray bulb).
Name This field displays a name to identify this rule.
Destination This parameter specifies the IP network address of the final destination. Routing is always
based on network number.
Gateway This is the IP address of the gateway. The gateway is a router or switch on the same
network segment as the device's LAN or WAN port. The gateway helps forward packets to
their destinations.
Subent Mask This parameter specifies the IP network subnet mask of the final destination.
Modify Click the Edit icon to open a screen where you can modify an existing rule.
Click the Delete icon to remove a rule from the EMG2926-Q10A.
Apply Click Apply to save your changes back to the EMG2926-Q10A.
Cancel Click Cancel to begin configuring this screen afresh.