User's Manual

Chapter 22 Remote Management
EMG2926-Q10A User’s Guide
156
22.5 Telnet Screen
To change your EMG2926-Q10A’s remote management settings, click M a nagem e n t > Re m ot e
MGMT > Te lnet to open the Telnet screen.
Figure 106 Management > Remote MGMT > Telnet
The following table describes the labels in this screen.
22.6 SNMP
Simple Network Management Protocol is a protocol used for exchanging management information
between network devices. Your EMG2926-Q10A supports SNMP agent functionality, which allows a
manager station to manage and monitor the EMG2926-Q10A through the network.
The EMG2926-
Q10A supports SNMP version one (SNMPv1) and version two (SNMPv2c). The next figure illustrates
an SNMP management operation.
Table 66 Management > Remote MGMT > Telnet
LABEL DESCRIPTION
Port You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Access Status Select the interface(s) through which a computer may access the EMG2926-Q10A
using this service.
Secured Client IP
Address
Select All to allow all computes to access the EMG2926-Q10A.
Otherwise, check Select e d and specify the IP address of the computer that can
access the EMG2926-Q10A.
Apply Click App ly to save your customized settings.
Cancel Click Ca ncel to begin configuring this screen afresh.