User's Manual

Chapter 23 Universal Plug-and-Play (UPnP)
EMG2926-Q10A User’s Guide
162
All UPnP-enabled devices may communicate freely with each other without additional configuration.
Disable UPnP if this is not your intention.
23.3 UPnP Screen
Use this screen to enable UPnP on your EMG2926-Q10A.
Click M a nagem e nt > UPn P to display the screen shown next.
Figure 110 Management > UPnP
The following table describes the fields in this screen.
23.4 Technical Reference
The sections show examples of using UPnP.
23.4.1 Using UPnP in Windows XP Example
This section shows you how to use the UPnP feature in Windows XP. You must already have UPnP
installed in Windows XP and UPnP activated on the EMG2926-Q10A.
Make sure the computer is connected to a LAN port of the EMG2926-Q10A. Turn on your computer
and the EMG2926-Q10A.
23.4.1.1 Auto-discover Your UPnP-enabled Network Device
1 Click st a rt and Control Panel. Double-click N et w or k Connections. An icon displays under
Internet Gateway.
2 Right-click the icon and select Proper t ie s.
Table 69 Management > UPnP
LABEL DESCRIPTION
UPnP Select Enable to activate UPnP. Be aware that anyone could use a UPnP application to
open the web configurator's login screen without entering the EMG2926-Q10A's IP
address (although you must still enter the password to access the web configurator).
Apply Click Apply to save the setting to the EMG2926-Q10A.
Cancel Click Cance l to return to the previously saved settings.