User's Manual

Chapter 26 Maintenance
EMG2926-Q10A User’s Guide
189
Note: If you select the incorrect system operation Mode you may not be able to connect
to the Internet.
Access Point Mode Select Acce ss Poin t M ode if your device bridges traffic between clients on the
same network.
•In Acce ss Poin t M ode , all Ethernet ports have the same IP address.
• All ports on the rear panel of the device are LAN ports, including the port
labeled WAN. There is no WAN port.
• The DHCP server on your device is disabled.
• Router functions (such as NAT, bandwidth management, remote management,
firewall and so on) are not available when the EMG2926-Q10A is in Access
Point Mode.
•
The IP address of the device on the local network is set to 192.168.0.2.
Apply Click App ly to save your settings.
Cancel Click Ca ncel to return your settings to the default (Rout er).
Table 80 Maintenance > Sys OP Mode (continued)
LABEL DESCRIPTION