User's Manual

Chapter 2 Connection Wizard
EMG2926-Q10A User’s Guide
26
Figure 14 Wireless Security: WPA2-PSK
The following table describes the labels in this screen.
Congratulations! Open a web browser, such as Internet Explorer, to visit your favorite website.
Note: If you cannot access the Internet when your computer is connected to one of the
EMG2926-Q10A’s LAN ports, check your connections. Then turn the EMG2926-
Q10A off, wait for a few seconds then turn it back on. If that does not work, log in
to the web configurator again and check you have typed all information correctly.
See the User’s Guide for more suggestions.
Table 7 Wireless Security: WPA2-PSK
LABEL DESCRIPTION
Wireless Radio Choose whether you want to apply the wireless security to 2 .4 G H z or 5 G Hz wireless
radio.
Wireless
Network Name
(SSID)
Enter a descriptive name (up to 32 printable 7-bit ASCII characters) for the wireless LAN.
If you change this field on the EMG2926-Q10A, make sure all wireless stations use the
same SSID in order to access the network.
Security Mode Select a security level from the drop-down list box.
Choose W PA2 - PSK security to configure a Pre-Shared Key. Choose this option only if your
wireless clients support WPA2-PSK.
Wireless
password
Type from 8 to 63 case-sensitive ASCII characters. You can set up the most secure wireless
connection by configuring WPA in the wireless LAN screens.
Verify Password Retype the password to confirm.
Exit Click this to close the wizard screen without saving.
Back Click this to return to the previous screen.
Next Click this to continue.